PoE Reference Calculator

Reference selector for Power over Ethernet. Choose a PoE type and cable parameters to see standard power levels, pair usage, channel-limit checks and cable guidance.

Interactive reference

Choose a PoE type to see the standard's reference values.

PoE standards

IEEE PoE types. PSE output is the maximum at the source; PD available is the maximum guaranteed to reach the powered device.
TypeStandardNameClassesPairsPSE WPD WA / pair
1IEEE 802.3afPoE0, 1, 2, 3215.412.950.35
2IEEE 802.3atPoE+423025.50.6
3IEEE 802.3btPoE++ / 4PPoE (Type 3)5, 6460510.6
4IEEE 802.3btPoE++ / 4PPoE (Type 4)7, 849071.30.96

Cable guidance for PoE

Statement-level guidance from the site's source-reviewed dataset. These are the same records that inform the tool's checks.

minimum cabling baseline

PoE is commonly deployed over balanced twisted-pair structured cabling; Cat5e or better is a practical baseline for modern Ethernet PoE installations.

Check the specific PSE/PD requirements, applicable cabling standard, conductor material, conductor gauge, channel resistance, connector ratings and installation conditions. Do not treat the category label alone as a guarantee.

conductor material

Use compliant copper conductors for standards-based PoE cabling; do not assume copper-clad aluminum (CCA) cable is suitable.

Confirm the cable's applicable listing and conductor resistance. Avoid recommending CCA for permanent structured cabling or higher-power PoE.

thermal management

PoE current causes resistive heating in cable conductors. Larger bundles, higher ambient temperature, higher current, smaller conductors and conduit can increase thermal risk.

Bundle size must be evaluated using applicable TIA/ISO/CENELEC remote-powering guidance and the actual cable construction, current, ambient temperature and installation method.

bundle size

CommScope summarizes a 24-cable bundle recommendation from remote-powering guidance as a general rule.

Do not turn 24 cables into a universal maximum. Larger bundles may be acceptable after engineering evaluation; smaller bundles may be appropriate in adverse conditions.

channel length

The common structured-cabling channel limit is 100 m, but the usable PD power is affected by channel resistance and power loss.

The 100 m channel length does not guarantee a particular power budget for every cable, connector, temperature or bundle configuration.

What this tool does not do

This tool does not calculate a guaranteed safe maximum cable length, does not model pairset current distribution, does not model unbalance or thermal rise in bundles, and does not substitute for the cable datasheet or for TIA/ISO/CENELEC remote-powering guidance.

Real PoE suitability needs: measured or datasheet loop resistance, current, ambient temperature, bundling, PSE and PD voltage ranges, conductor material and the actual installation conditions. Where these are missing, this tool says so rather than returning a confident false answer.

Sources

Published · Last reviewed