Ethernet Cable AWG Chart

Nominal conductor diameter, cross-sectional area and theoretical single-conductor DC resistance for the AWG sizes commonly found in Ethernet cable.

Reference table

Theoretical single-conductor values for solid bare copper at 20 °C. These are calculated reference figures, not finished-cable acceptance limits or product datasheet values.
AWGDiameter (mm)Area (mm²)Theoretical DC resistance (Ω/km at 20 °C)
220.6440.32653.5
230.5730.25867.7
240.5110.20585.0
250.4550.162107.2
260.4050.129135.2
280.3210.081212.9

What these values mean

These are theoretical single-conductor values, derived from nominal AWG geometry and a copper reference resistivity. They describe the electrical behaviour of one conductor at a stated temperature, not of a finished cable under installation conditions.

A real cable's DC resistance can differ from these figures due to strand construction (stranded conductors have slightly higher resistance than solid at the same nominal AWG), conductor plating, manufacturing tolerances and actual conductor temperature during operation.

For PoE, resistance affects voltage drop and dissipated power in the cable. Two-way loop resistance is twice the single-conductor value, and a PoE pairset uses two conductors per polarity — so a complete engineering calculation needs a more detailed model than simply multiplying the figures above.

Derivation basis

Nominal AWG diameter combined with commercial annealed copper reference resistivity (approximately 17.241 nOhm.m at 20 C, per IEC 60028). Calculated via R = (rho * L) / A. Not a cable acceptance limit or finished-cable DCR requirement.

Temperature correction follows the standard linear approximation for copper: RT = R20 × [1 + α × (T − 20)], with α ≈ 0.00393/°C near 20 °C. Actual resistance increases with temperature, which is relevant for bundled cables carrying PoE current.

Published · Last reviewed