Select a cable category, an Ethernet application and a channel length. Returns one of four documented states: within documented limits, condition-dependent, outside documented limits, or insufficient data. Special-cases Cat6 at 10GBASE-T.
Compare any two Ethernet cable categories side by side: ISO/IEC class, frequency, channel and permanent-link length, typical application support, 10G reach, construction notes and caveats.
Reference selector for IEEE 802.3af / at / bt: PSE output vs PD available power, pairs energized, channel-limit check, AWG resistance reference and conductor-material checks. Explicit warnings at every result — not a compliance or safety tool.
Enter an application, distance, PoE type and environment; receive a recommended minimum category plus a structured checklist of what to confirm independently.
Deferred
These tools are scoped in the project data but not yet built:
AWG Resistance Calculator — single-conductor and loop resistance from AWG, length and temperature. Until then, see the AWG chart.
Cable Length Planner — pull length and channel length estimate from route details. Until then, seemaximum cable length.
What the tools will not do
None of the tools certifies an installed cable, replaces a product datasheet, or substitutes for the applicable standards and local code requirements. They show documented limits, highlight missing data and surface the conditions that apply.
Where a design decision affects a result — for example whether a PoE check should return "conditional" versus "unsupported" for an unusual combination — the tool says so rather than returning a confident false answer. This matches the dataset policy: preserve unknown values, do not fill gaps by inference.