Ethernet Cable Connectors

The connectors used in balanced twisted-pair Ethernet: modular plugs, jacks, patch panels and field-termination systems, with the selection checks that matter.

Connector types

8P8C modular plug (commonly called RJ45) Verified

Function: Male modular connector commonly used on Ethernet patch cords and field-terminated cables

Selection checks:

  • connector category/performance rating
  • solid or stranded conductor compatibility
  • AWG range
  • insulation/conductor diameter
  • cable outer-jacket diameter
  • shielded or unshielded construction
  • compatible crimp tool and plug design

Caveats:

  • RJ45 is the common industry term, while 8P8C describes the eight-position/eight-contact form factor
  • Not every 8P8C plug is suitable for every Ethernet category or cable
  • Do not assume a plug advertised as Cat6 fits Cat6A cable

Keystone jack Verified

Function: Modular female jack commonly used in wall plates, patch panels and surface boxes

Selection checks:

  • category/class rating
  • shielded or unshielded compatibility
  • IDC conductor gauge range
  • solid-conductor support for horizontal cable
  • T568A or T568B termination labels
  • compatible faceplate or patch panel

Caveats:

  • Rear IDC colour positions vary by jack design; follow the printed A/B legend and product instructions
  • Use a short patch cord between the permanent link jack and equipment

Shielded modular plug Verified

Function: Modular plug with conductive housing or shield-contact structure intended to maintain cable-screen continuity

Selection checks:

  • compatible cable shield construction
  • shield capture/contact design
  • drain-wire instructions
  • compatible shielded jack or equipment interface
  • overall bonding design

Caveats:

  • Shield performance depends on the complete channel and correct manufacturer-specific termination
  • A metal plug alone does not guarantee a properly bonded shielded system

Field-termination plug Product-specific

Function: On-site plug terminated using IDC, tool-less or manufacturer-specific termination method

Selection checks:

  • exact cable construction and diameter
  • solid/stranded compatibility
  • specified termination tool or procedure
  • category and PoE suitability where relevant

Caveats:

  • Field plugs are not universally compatible; check the exact product datasheet

Ethernet patch panel Verified

Function: Central termination point for horizontal structured cabling, typically using IDC terminations

Selection checks:

  • category/class
  • port count and form factor
  • shielded/unshielded system
  • IDC conductor range
  • rack or enclosure compatibility
  • bonding instructions for shielded models

Caveats:

  • Patch panel category and installation quality are part of the channel performance; do not infer certification from appearance

Common selection mistakes

Matching on category label alone. A plug or jack sold as "Cat6" is not automatically suitable for every Cat6 cable. Conductor AWG, insulation diameter and jacket diameter must all fall within the connector's specified range.

Assuming a shielded plug creates a shielded system.Shield continuity depends on the cable's shield construction, the plug's shield-capture design, the jack's bonding, and the overall grounding/bonding plan. A metal plug on an unshielded cable provides no meaningful shielding.

Using plugs where jacks belong. In fixed horizontal cabling, a jack or patch-panel termination is the standard approach. Field-termination plugs exist but are product-specific — check the manufacturer's stated compatibility with your exact cable construction.

Skipping the test step. A visual colour check proves the wiring scheme was applied, not that the pair integrity is correct. Test wire map, opens, shorts, reversals, split pairs and category-appropriate performance. See thewiring reference for termination practices.

Sources

Published · Last reviewed